Corn puffing machine is a common puffing equipment. Before using the corn expander, it must be debugged to ensure that it can work smoothly. What should debugging do?
Here's an introduction:
1. Before using, first remove the sprinkler of corn expander, apply some edible oil on the inner thread and screw head of the sprinkler, then tighten the sprinkler, tighten the front flange, and evenly adjust the back flange.
2. After startup, idle for half a minute. If there is no abnormal sound, the wet corn can be put into the machine. When the sprayed corn flower can be crushed by hand, it can be replaced by dry corn, and gradually increase the input.
3. If the phenomenon of returning material occurs in the corn expander during operation, it means that the cutting is too urgent and the temperature of the sprinkler can not reach 120 degrees. At this time, the cutting should be stopped, and then the blanking should be transferred to the sprinkler when it sprays again. If the flower of the sprinkler has hard core, it means that the temperature in the machine is low, the blanking should stop idling for a while, and then blanking after the sprinkler is normal.
In addition, how should we maintain the expander equipment after use? Firstly, because the wear of the vulnerable parts near the outlet is relatively fast, and the wear of the vulnerable parts near the inlet and outlet is less, when replacing the vulnerable parts, we should replace the vulnerable parts in turn from the outlet, not a variety of parts at one time, and then the expanding materials should be cleared. Reasonable, strictly prevent foreign bodies such as metal from entering the machine to damage the machine parts, check the quality of the expander at any time, pay attention to the replacement of vulnerable parts.
